B225A Tail Gate Panel Position Switch RH
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The No. 2 main body ECU receives the close position switch signal from the lower tail gate lock assembly RH and detects the open/closed status of the lower tail gate. DTC B225A is stored when the No. 2 main body ECU receives a close position switch malfunction signal from the lower tail gate lock assembly RH.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B225A |
A close position switch malfunction (open or short circuit) signal is received from the lower tail gate lock. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (POSITION SWITCH RH) |
Check the Data List for proper functioning of the close position switch (Click here).
Body No. 4 Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Position Switch RH
Close position switch RH signal / ON or OFF
ON: Lower tail gate closed
OFF: Lower tail gate open
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT |
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Check for DTCs (Click here).
Clear the DTCs (Click here).
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Recheck for DTCs (Click here).
- OK:
- DTC B225A is not output.
|
|
||||
| OK | ||
| ||
| 3. INSPECT LOWER TAIL GATE LOCK ASSEMBLY RH |
Remove the lower tail gate lock assembly RH (Click here).
Inspect the lower tail gate lock assembly RH (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (LOWER TAIL GATE LOCK ASSEMBLY RH - NO. 2 MAIN BODY ECU AND BODY GROUND) |
Disconnect the h4 lower tail gate lock assembly RH connector.
Disconnect the L50 No. 2 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
h4-7 (HND) - L50-17 (LMT)
Always
Below 1 Ω
h4-8 (GND) - Body ground
Always
Below 1 Ω
h4-7 (HND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
