B2251 Back Door Closer Switch Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The power back door unit assembly (power back door ECU) inputs signals from the latch switch, closer position switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2251 |
While back door closer is operating, malfunction is detected in position information from each switch within specified amount of time |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (BACK DOOR LOCK) |
Check the Data List for proper functioning of each switch (Click here).
Back Door Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Half Latch SW
Latch switch signal / ON or OFF
ON: Latch switch is on
OFF: Latch switch is off
-
Courtesy SW
Back door courtesy switch signal / ON or OFF
ON: Back door courtesy switch is on
OFF: Back door courtesy switch is off
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 2. INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH) |
Remove the back door lock assembly (Click here).
Inspect the back door lock assembly (Click here).
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND) |
Disconnect the S22 back door lock assembly connector.
Disconnect the L52 power back door unit assembly (power back door ECU) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
S22-5 (CLS) - L52-22 (HAF)
Always
Below 1 Ω
S22-3 (CTY) - L52-20 (FUL)
Always
Below 1 Ω
S22-4 (E) - Body ground
Always
Below 1 Ω
S22-5 (CLS) - Body ground
Always
10 kΩ or higher
S22-3 (CTY) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
