C1613 ACC Voltage is Low or High
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal ACC is not normal.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1613 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
| 1. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC C1613 is output
A
No DTC is output
B
- HINT:
- If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU ACC VOLTAGE) |
Disconnect the F43 connector from the parking assist ECU.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F43-14 (ACC) - F43-4 (GND1)
Engine switch on (ACC)
11 to 14 V
| *1 |
Front view of wire harness connector (to Parking Assist ECU) |
|
|
||||
| OK | ||
| ||
