Home › Engine / Hybrid System › 1UR-FE (ENGINE CONTROL) › THROTTLE BODY
RM2660E _51 Engine / Hybrid System _052772 1UR-FE ENGINE CONTROL _0254969 THROTTLE BODY A

1UR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 53806 1.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 17705 6.REMOVE AIR CLEANER CAP AND HOSE

a.
A456915

Disconnect the No. 2 PCV hose and No. 1 air hose.


b.

Disconnect the mass air flow meter connector and detach the clamp.


c.

Detach the 4 clamps.


d.

Loosen the hose clamp and remove the air cleaner cap and hose.


Hide 22030 7.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A271377

Disconnect the No. 4 water by-pass hose and No. 12 water by-pass hose.


b.

Disconnect the throttle position sensor and control motor connector.


c.
A215292

Remove the 4 bolts, throttle body with motor assembly and gasket.


d.
A230332

Remove the No. 12 water by-pass hose from the throttle body with motor assembly.


e.
A230333

Remove the No. 4 water by-pass hose from the throttle body with motor assembly.