89465A
1.INSTALL NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
| *1 | Fulcrum Length |
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
89465
2.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
| *1 | Fulcrum Length |
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
17410
3.INSTALL FRONT EXHAUST PIPE ASSEMBLY
17450B
4.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
5.INSPECT FOR EXHAUST GAS LEAK
51442
6.INSTALL NO. 2 ENGINE UNDER COVER