Home › Engine / Hybrid System › 1VD-FTV (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › 2015.08–2017.08
RM2660E _51 Engine / Hybrid System _052779 1VD-FTV ENGINE MECHANICAL _0255069 REAR CRANKSHAFT OIL SEAL A

1VD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 33030 4.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

Hide 31210 5.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 6.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 32101 7.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

Hide 13405 8.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

Hide 11381A 9.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A177361E04
0.813,3.104 1.26,3.104 false 0.813,2.729 1.26,2.729 false 1.292,3.01 1.479,3.167 0.188,0.156 10 false *2 1.281,2.646 1.469,2.802 0.188,0.156 10 false *1

Using a knife, cut off the lip of the oil seal.

Text in Illustration
*1 Cut Position
*2 Oil Seal


b.

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the crankshaft.


HINT:

Tape the screwdriver tip before use.