Home › Engine / Hybrid System › 1UR-FE (FUEL) › FUEL PRESSURE REGULATOR › from 2015.08
RM2660E _51 Engine / Hybrid System _052782 1UR-FE FUEL _0255098 FUEL PRESSURE REGULATOR A

1UR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 23280 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A218699

Disconnect the No. 2 fuel tube from the pressure regulator (See page Engine / Hybrid System>1UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).

CAUTION:

Put a cloth or equivalent under the pressure regulator.



b.
A218700

Remove the No. 1 air hose from the pressure regulator.


c.
A218701

Remove the 2 bolts, and then pull out the pressure regulator.


d.

Remove the O-ring from the pressure regulator.