1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
53806
2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Viscous Heater)
53805
3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Viscous Heater)
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)
53292A
5.REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Viscous Heater)
6.DRAIN ENGINE COOLANT (w/ Viscous Heater)
17940D
7.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)
17971
8.REMOVE NO. 1 COOL AIR INLET (w/o Intercooler)
17972
9.REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)
87209
10.DISCONNECT WATER HOSE SUB-ASSEMBLY (w/ Viscous Heater)
17705
11.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17881
12.REMOVE NO. 1 AIR CLEANER HOSE
17861
13.REMOVE INTAKE AIR CONNECTOR
87208
14.REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)
17885
15.REMOVE NO. 1 AIR CLEANER PIPE SUB-ASSEMBLY
89454
16.REMOVE FUEL TEMPERATURE SENSOR
Before replacing the fuel temperature sensor, be sure to clean the surrounding area.
When replacing the fuel temperature sensor, make sure that your hands are clean and do not use gloves, etc.
If the fuel temperature sensor is dropped, replace it with a new one.
Disconnect the fuel temperature sensor connector.
Using SST, remove the fuel temperature sensor.
Remove the O-ring from the fuel temperature sensor.