Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL TEMPERATURE SENSOR › from 2015.08
RM2660E _51 Engine / Hybrid System _052783 1VD-FTV FUEL _0255122 FUEL TEMPERATURE SENSOR A

1VD-FTV FUEL  FUEL TEMPERATURE SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Viscous Heater)

Hide 53805 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Viscous Heater)

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

Hide 53292A 5.REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Viscous Heater)

Hide 6.DRAIN ENGINE COOLANT (w/ Viscous Heater)

Hide 17940D 7.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 17971 8.REMOVE NO. 1 COOL AIR INLET (w/o Intercooler)

Hide 17972 9.REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)

Hide 87209 10.DISCONNECT WATER HOSE SUB-ASSEMBLY (w/ Viscous Heater)

Hide 87208 14.REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)

Hide 17885 15.REMOVE NO. 1 AIR CLEANER PIPE SUB-ASSEMBLY

Hide 89454 16.REMOVE FUEL TEMPERATURE SENSOR

NOTICE:
·

Before replacing the fuel temperature sensor, be sure to clean the surrounding area.

·

When replacing the fuel temperature sensor, make sure that your hands are clean and do not use gloves, etc.

·

If the fuel temperature sensor is dropped, replace it with a new one.



a.
A176374

Disconnect the fuel temperature sensor connector.


b.

Using SST, remove the fuel temperature sensor.

SST
09817-33190  


c.

Remove the O-ring from the fuel temperature sensor.