Home › Engine / Hybrid System › 3UR-FE (INTAKE / EXHAUST) › EXHAUST MANIFOLD › 2014.08–2017.08
RM2660E _51 Engine / Hybrid System _052789 3UR-FE INTAKE / EXHAUST _0255168 EXHAUST MANIFOLD A

3UR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 53806 1.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53736G 5.REMOVE FRONT FENDER APRON SEAL FRONT RH

a.
A177003

Using a clip remover, remove the 3 clips and fender apron seal.


Hide 53738A 6.REMOVE FRONT FENDER APRON SEAL REAR RH

a.
A177002

Using a clip remover, remove the 4 clips and fender apron seal.


Hide 53737B 7.REMOVE FRONT FENDER APRON SEAL LH

a.
A177004

Using a clip remover, remove the 3 clips and fender apron seal.


Hide 53739A 8.REMOVE FRONT FENDER APRON SEAL REAR LH

a.
A177005

Using a clip remover, remove the 4 clips and fender apron seal.


Hide 11452 9.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 17420 11.REMOVE CENTER EXHAUST PIPE ASSEMBLY

Hide 17450B 12.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

Hide 17410 13.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 37117 14.REMOVE PROPELLER SHAFT HEAT INSULATOR

a.
A175007

Remove the 2 bolts and heat insulator.


Hide 17119 15.REMOVE NO. 2 MANIFOLD STAY

a.
A184508

Remove the 3 bolts and No. 2 manifold stay.


Hide 17168 16.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A184509

Remove the 3 bolts and heat insulator.


Hide 17105 17.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.
A184536

Disconnect the connector and detach the wire harness clamp.


b.
A236969

Remove the 8 nuts, exhaust manifold sub-assembly LH and gasket.


Hide 17118 18.REMOVE NO. 1 MANIFOLD STAY

a.
A184511

Remove the 3 bolts and No. 1 manifold stay.


Hide 17167 19.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A184512

Remove the 3 bolts and heat insulator.


Hide 17104 20.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.
A184535

Disconnect the connector and detach the wire harness clamp.


b.
A236970

Remove the 8 nuts, exhaust manifold sub-assembly RH and gasket.


Hide 89467B 21.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

Hide 89467C 22.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)