Home › Engine / Hybrid System › 1VD-FTV (INTAKE / EXHAUST) › EXHAUST PIPE(w/ DPF) › from 2015.08
RM2660E _51 Engine / Hybrid System _052790 1VD-FTV INTAKE / EXHAUST _0255177 EXHAUST PIPE(w/ DPF) A

1VD-FTV INTAKE / EXHAUST  EXHAUST PIPE(w/ DPF)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves and protective glasses when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 53785B 3.REMOVE FRONT FENDER APRON SEAL REAR LH

Hide 51442 4.REMOVE NO. 2 ENGINE UNDER COVER

a.
C173930

Remove the 6 bolts and No. 2 engine under cover.


Hide 17430 5.REMOVE TAILPIPE ASSEMBLY

a.

Remove the bolt, clamp and gasket.


b.

Disconnect the tailpipe from the 2 exhaust pipe supports.


Hide 17420 6.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 4 bolts and 2 compression springs.


b.

Disconnect the center exhaust pipe from the 3 exhaust pipe supports.


c.

Remove the gasket from the No. 5 exhaust pipe and front exhaust pipe.


Hide 17410 10.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A370240

Slide the 2 clamps and disconnect the 2 air hoses from the front exhaust pipe assembly.


b.

Disconnect the exhaust gas temperature sensor connector and detach the clamp.


c.

Remove the 3 nuts and front exhaust pipe.


d.

Remove the gasket.


Hide 17450 11.REMOVE NO. 5 EXHAUST PIPE ASSEMBLY

a.

Remove the 2 nuts and No. 5 exhaust pipe.


b.

Remove the gasket.


Hide 17450B 12.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.
A267198

Disconnect the 2 air hoses.


b.

Disconnect the exhaust gas temperature sensor connector and detach the clamp.


c.

Remove the 3 nuts and front No. 2 exhaust pipe.


d.

Remove the gasket.


Hide 18450A 14.REMOVE MONOLITHIC CONVERTER ASSEMBLY RH

a.
A267200

Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.


b.
A267201

Remove the 3 bolts and manifold stay.


c.

Remove the 3 nuts and monolithic converter RH.


d.

Remove the gasket from the turbocharger.


Hide 37140 15.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 18460 16.REMOVE MONOLITHIC CONVERTER ASSEMBLY LH

a.
A267202

Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.


b.
A267204

Remove the 3 bolts and No. 2 manifold stay.


c.

Remove the 3 nuts and monolithic converter LH.


d.

Remove the gasket from the turbocharger.