Home › Engine / Hybrid System › 1GR-FE (COOLING) › RADIATOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052792 1GR-FE COOLING _0255186 RADIATOR A

1GR-FE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 16400 1.INSTALL RADIATOR ASSEMBLY

a.
A174324

Set the radiator bracket hooks into the radiator support holes.


b.

Install the radiator with the 4 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 32922A 2.CONNECT OUTLET OIL COOLER HOSE (for Automatic Transmission)

a.

Connect the cooler hose.


Hide 32921D 3.CONNECT INLET OIL COOLER HOSE (for Automatic Transmission)

a.

Connect the cooler hose.


Hide 16711 4.INSTALL FAN SHROUD

a.

Install the fan pulley to the water pump.


b.

Place the shroud together with the coupling fan between the radiator and engine.

NOTICE:

Be careful not to damage the radiator core.



c.

Temporarily install the fluid coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.

NOTICE:

Match the paint marks on the heads of the water pump studs with the paint marks on the flange of the fluid coupling and install the fluid coupling.



d.
A273662

Attach the claws of the shroud to the radiator as shown in the illustration.


e.

Install the shroud with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.

Connect the reservoir hose to the upper side of the radiator tank.


g.

Install the fan and generator V-belt (See page Engine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION).


h.

Tighten the 4 nuts of the fluid coupling fan.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 32907A 5.CONNECT OIL COOLER TUBE (w/ Air Cooled Transmission Oil Cooler)

a.

Connect the oil cooler tube with the 2 bolts, and attach the claw to close the flexible hose clamp.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 16572D 6.INSTALL NO. 2 RADIATOR HOSE

a.

Install the No. 2 radiator hose and attach the clamp.


Hide 16571C 7.INSTALL NO. 1 RADIATOR HOSE

Hide 53294C 8.INSTALL RADIATOR SIDE DEFLECTOR LH

a.

Install the deflector with the 4 clips.


Hide 53293C 9.INSTALL RADIATOR SIDE DEFLECTOR RH (w/o Air Cooled Transmission Oil Cooler)

a.

Install the deflector with the 4 clips.


Hide 32917 10.INSTALL TRANSMISSION OIL COOLER AIR DUCT (w/ Air Cooled Transmission Oil Cooler)

a.

Install the oil cooler air duct with the 4 bolts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 51405A 14.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52119A 15.INSTALL FRONT BUMPER COVER (for Standard)

Hide 52119A 16.INSTALL FRONT BUMPER COVER (w/ Winch)