Home › Engine / Hybrid System › 3UR-FE (COOLING) › RADIATOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052793 3UR-FE COOLING _0255191 RADIATOR A

3UR-FE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 16400 1.INSTALL RADIATOR ASSEMBLY

a.
A174207

Set the radiator bracket hooks to the radiator support holes.


b.

Install the radiator with the 4 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


c.

Connect the 2 oil cooler hoses.


Hide 16711 2.INSTALL FAN SHROUD

a.

Install the fan pulley.


b.

Place the shroud together with the coupling fan between the radiator and engine.

NOTICE:

Be careful not to damage the radiator core.



c.

Temporarily install the fluid coupling fan to the fluid coupling bracket with the 4 nuts. Tighten the nuts as much as possible by hand.


d.
A241407

Attach the claws of the shroud to the radiator as shown in the illustration.


e.

Install the shroud with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.

Connect the oil cooler tube to the fan shroud with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


g.

Pass the hose through the flexible hose clamp and close the clamp as shown in the illustration.


h.

Connect the reservoir hose to the upper radiator tank.


i.

Install the fan and generator V-belt (See page Engine / Hybrid System>3UR-FE (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION).


j.

Tighten the 4 nuts of the fluid coupling fan.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 16572D 3.INSTALL NO. 2 RADIATOR HOSE

Hide 16571C 4.INSTALL NO. 1 RADIATOR HOSE

Hide 51405A 9.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 10.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 11.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53294C 12.CONNECT RADIATOR SIDE DEFLECTOR LH

a.

Connect the deflector with the 4 clips.


Hide 32917 13.INSTALL TRANSMISSION OIL COOLER AIR DUCT

a.

Install the oil cooler air duct with the 4 bolts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 53292A 16.INSTALL UPPER RADIATOR SUPPORT SEAL