Home › Engine / Hybrid System › 3UR-FE (COOLING) › RADIATOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052793 3UR-FE COOLING _0255191 RADIATOR A

3UR-FE COOLING  RADIATOR  REMOVAL  


PROCEDURE

Hide 53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 32917 4.REMOVE TRANSMISSION OIL COOLER AIR DUCT

a.
A271852

Remove the 4 bolts and oil cooler air duct.


Hide 53294C 5.DISCONNECT RADIATOR SIDE DEFLECTOR LH

a.
A271854

Using a clip remover, remove the 4 clips and disconnect the side deflector.


Hide 53806 6.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 7.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 16571C 12.REMOVE NO. 1 RADIATOR HOSE

Hide 16572D 13.REMOVE NO. 2 RADIATOR HOSE

Hide 16711 14.REMOVE FAN SHROUD

a.
A151842

Loosen the 4 nuts holding the fluid coupling fan.


b.

Remove the fan and generator V-belt (See page Engine / Hybrid System>3UR-FE (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


c.
A238869

Disconnect the reservoir hose from the upper radiator tank.


d.

Detach the claw to open the flexible hose clamp.


e.

Remove the 2 bolts and disconnect the oil cooler tube from the fan shroud.


f.

Remove the 2 bolts holding the fan shroud.


g.

Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

NOTICE:

Be careful not to damage the radiator core.



h.

Remove the fan pulley.


Hide 16400 15.REMOVE RADIATOR ASSEMBLY

a.
A174209

Disconnect the 2 oil cooler hoses.


b.
A174155

Remove the 4 bolts and radiator.