Home › Engine / Hybrid System › 1VD-FTV (LUBRICATION) › OIL LEVEL SENSOR
RM2660E _51 Engine / Hybrid System _052799 1VD-FTV LUBRICATION _0255223 OIL LEVEL SENSOR A

1VD-FTV LUBRICATION  OIL LEVEL SENSOR  INSTALLATION  


PROCEDURE

Hide 89491 1.INSTALL ENGINE OIL LEVEL SENSOR

a.

Install a new gasket to the sensor.


b.
A170283

Install the sensor with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 32907A 2.CONNECT OIL COOLER TUBE (for Automatic Transmission)

a.
U163244E02
3.094,0.823 3.25,0.99 0.156,0.167 10 false A 0.958,0.563 1.115,0.729 0.156,0.167 10 false B 1.135,1.802 1.292,1.969 0.156,0.167 10 false C

Temporarily install the oil cooler tube to the engine with the 2 bolts A and B.


b.

Install the bolt C and tighten it to the specified torque. Then tighten the bolt A and B to the specified torque.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)


Hide 51405A 7.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53805 8.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53806 9.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53736G 11.INSTALL FRONT FENDER APRON SEAL FRONT RH