Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for LHD) › 2015.08–2018.08
RM2660E _52 Drivetrain _052808 CLUTCH _0255312 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.
C173224

Install the clutch master cylinder with the 2 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


b.
C358745E01
0.458,1.854 1.833,2.052 1.375,0.198 10 false MP grease

Apply MP grease to the contact surface of the clevis pin and clevis bush.


c.

Install the wave washer to the clevis pin.


d.

Connect the clevis of the master cylinder to the clutch pedal with the clevis pin.


e.

Install a new clip to the clevis pin.


Hide 84520 2.INSTALL CLUTCH START SWITCH ASSEMBLY

C173223

a.

Install the clutch start switch to the clutch pedal bracket, and then temporarily install the 2 nuts.

HINT:

The 2 nuts will be tightened to a torque specification in the "Adjust Clutch Start Switch Assembly" procedure.



Hide 31481J 3.INSTALL CLUTCH MASTER CYLINDER TO WAY TUBE

C249774

a.

Using a union nut wrench, install the tube to the clutch master cylinder and clutch pedal support way.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 31434 4.INSTALL CLUTCH RESERVOIR HOSE

C173228

a.

Install the clutch reservoir hose to the clutch master cylinder and clutch pedal support way with 2 new clips.

NOTICE:

Connect the clutch reservoir hose so that it will not be twisted.



Hide 55107A 5.INSTALL CLUTCH PEDAL SUPPORT ASSEMBLY WITH CLUTCH MASTER CYLINDER

Hide 31481 6.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE AND CLUTCH RESERVOIR TUBE

Hide 82733A 7.INSTALL MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

Hide 8.FILL RESERVOIR WITH BRAKE FLUID

Hide 31301 10.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY

Hide 84520 11.ADJUST CLUTCH START SWITCH ASSEMBLY

a.
C175188

While depressing the clutch pedal, tighten the 2 nuts so that the clearance between the clutch pedal and clutch start switch is within the specification.

Standard clearance between clutch pedal and clutch start switch:

4.1 to 6.1 mm (0.162 to 0.240 in.)


Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 12.CHECK FLUID LEVEL IN RESERVOIR

Hide 13.INSPECT FOR CLUTCH FLUID LEAK

Hide 55303B 14.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 73900 15.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)