Home › Steering › VARIABLE GEAR RATIO STEERING › STEERING CONTROL ECU (for LHD) › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255450 STEERING CONTROL ECU(for LHD) A

VARIABLE GEAR RATIO STEERING  STEERING CONTROL ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 89181A 1.INSTALL STEERING CONTROL ECU

a.

Attach the 2 claws and install the steering control ECU to the junction block with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 2.INSTALL STEERING CONTROL ECU WITH JUNCTION BLOCK

a.

Install the steering control ECU with junction block with the bolt and 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the connectors and wire harness clamp.


Hide 55312 4.INSTALL LOWER INSTRUMENT PANEL (w/o Driver Side Knee Airbag)

Hide 73900 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7. VARIABLE GEAR RATIO STEERINGSYSTEM CALIBRATION