Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255329 TRANSFER SYSTEM C

JF2A TRANSFER / 4WD / AWD  TRANSFER SYSTEM  P17C2  Rear Differential Lock Shift Motor Circuit Open  


DESCRIPTION

This DTC is output when an open circuit in the differential lock shift motor drive circuit is detected.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P17C2
1.

When rear differential is switching between free and lock (differential lock shift motor operating) with ignition switch turned to ON

2.

Open circuit in the differential lock shift motor drive circuit

3.

0.03 seconds or more

4.

1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Differential lock shift actuator



WIRING DIAGRAM

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU -DIFFERENTIAL LOCK SHIFT ACTUATOR)
a.

Disconnect the A28 4 wheel drive control ECU connector.


b.

Disconnect the f1 differential lock shift actuator connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A28-3 (M1) - f1-3 Always Below 1 Ω
A28-9 (M2) - f1-2 Always Below 1 Ω




OK

2.INSPECT DIFFERENTIAL LOCK SHIFT ACTUATOR (DIFFERENTIAL LOCK SHIFT MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT DIFFERENTIAL LOCK SHIFT ACTUATOR (DIFFERENTIAL LOCK SHIFT MOTOR)
a.

Disconnect the f1 differential lock shift actuator connector.


C341715E01
0.176,0 0.568,0.225 0.392,0.225 10 *a

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 2 Always 100 Ω or less


Text in Illustration
*a Component without harness connected
(Differential Lock Shift Actuator)

Result:
Result Proceed to
OK for LHD A
for RHD B
NG C




A

B

C