Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU (for RHD) › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255342 4WD CONTROL ECU(for RHD) A

JF2A TRANSFER / 4WD / AWD  4WD CONTROL ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

w/ Driver Side Knee Airbag:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55448A 3.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55474C 5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 6.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55606 8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55432D 10.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 12.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 13.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 89533 15.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.
C331268

Remove the bolt.


b.

Detach the 2 guides and disconnect the 4 wheel drive control ECU.


c.

Disconnect the 2 connectors from the 4 wheel drive control ECU.