Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU (for LHD) › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255341 4WD CONTROL ECU(for LHD) A

JF2A TRANSFER / 4WD / AWD  4WD CONTROL ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

w/ Passenger Side Knee Airbag:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55448A 3.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 73990 8.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 55312 9.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

Hide 55476A 10.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55443D 11.REMOVE INSTRUMENT PANEL BOX DOOR KNOB

Hide 55433B 12.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 89533 14.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.
C331275

Remove the bolt.


b.

Detach the 2 guides and disconnect the 4 wheel drive control ECU.


c.

Disconnect the 2 connectors from the 4 wheel drive control ECU.