Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
48630
1.TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH
Temporarily install the suspension upper arm with the 2 washers, bolt and nut.
After stabilizing the suspension, tighten the nut.
43212
2.CONNECT STEERING KNUCKLE LH
Connect the steering knuckle to the suspension upper arm.
Install a new nut and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
89516
3.CONNECT SKID CONTROL SENSOR WIRE
Connect the sensor wire to the steering knuckle and upper arm with the bolt and nut.
4.STABILIZE SUSPENSION
48630
5.TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH
Tighten the nut.
Perform this procedure with all 4 wheels on the ground.
89406
6.INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)
53785B
7.INSTALL FRONT FENDER APRON TRIM PACKING D
Install the apron trim packing with the 4 clips.
53783
8.INSTALL FRONT FENDER APRON TRIM PACKING B (w/ KDSS)
Install the apron trim packing with the 3 clips.
53783
9.INSTALL FRONT FENDER APRON TRIM PACKING B (w/o KDSS)
Install the apron trim packing with the 4 clips.
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Active Height Control)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11.PERFORM VEHICLE HEIGHT OFFSET CALIBRATION (w/ Active Height Control)
Perform the vehicle height offset calibration (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
89406
12.ADJUST FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)
13.PERFORM ZERO POINT CALIBRATION OF G SENSOR (w/ Active Height Control)
Perform the zero point calibration of G sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION ).
14.MEASURE VEHICLE HEIGHT (w/ KDSS)
48860D
15.CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
48826D
16.INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
17.ADJUST HEADLIGHT ASSEMBLY
for Halogen Headlight:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Halogen Headlight)>ADJUSTMENT).
for LED Headlight:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>ADJUSTMENT).
for Halogen Headlight and LED Headlight:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight and LED Headlight)>ADJUSTMENT).