Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › 2014.08–2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255399 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  INSTALLATION  


PROCEDURE

Hide 89760C 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

a.

Connect the connector to the tire pressure warning ECU and receiver.


b.

Attach the guide and clamp to temporarily install the tire pressure warning ECU and receiver.


c.
C311867E02
0.354,0.198 0.698,0.469 0.344,0.271 10 false *a 1.771,0.188 2.052,0.479 0.281,0.292 10 false *b

Install the bolt.

Torque:
Bolt A : 13 N*m (127 kgf*cm, 9 ft.*lbf)
Bolt B : 8.3 N*m (85 kgf*cm, 73 in.*lbf)

Text in Illustration
*a Bolt A
*b Bolt B

NOTICE:

The different marks on the heads of the bolts are shown in the illustration. Check whether the bolt being used is bolt A or bolt B, and then tighten the bolt using the appropriate torque.



Hide 62510P 2.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).