Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255409 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 89245B 1.INSTALL STEERING ANGLE SENSOR

a.
C358533E01
1.417,0.177 1.51,0.177 1.51,0.177 1.813,0.479 false 2.573,1.635 2.573,0.99 false 1.156,0.083 1.479,0.271 0.323,0.188 10 false Pin 2.458,1.688 2.917,1.885 0.458,0.198 10 false Pin

Align the installation holes on the steering sensor with the pins on the spiral cable.


b.

Attach the 6 claws and install the steering sensor to the spiral cable.


Hide 45100 6.INSTALL STEERING WHEEL ASSEMBLY

Hide 45186 8.INSTALL LOWER NO. 2 STEERING WHEEL COVER

Hide 45187 9.INSTALL LOWER NO. 3 STEERING WHEEL COVER

Hide 28800 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
·

Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 11.CHECK SRS WARNING LIGHT