Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  VSC Buzzer Circuit  


DESCRIPTION

The skid control ECU (master cylinder solenoid) is connected to the combination meter assembly via CAN communication.

The combination meter assembly has a built-in buzzer.

WIRING DIAGRAM

C230884E30
1.01,0.917 1.74,1.167 0.729,0.25 10 false Buzzer 0.49,1.802 0.979,2.042 0.49,0.24 10 false E119 0.479,2.01 2.417,2.281 1.938,0.271 10 false Combination Meter Assembly 0.875,2.427 2.813,2.698 1.938,0.271 10 false : CAN Communication System 5.406,1.333 5.865,1.531 0.458,0.198 10 false A24 5.396,1.531 7.083,1.948 1.688,0.417 10 false Skid Control ECU (Master Cylinder Solenoid)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

3.PERFORM ACTIVE TEST USING GTS (BUZZER)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Buzzer Buzzer ON/OFF The buzzer can be heard.


f.

When performing the Buzzer Active Test, check Buzzer in the Data List (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Buzzer Buzzer/ ON or OFF ON: Buzzer on
OFF: Buzzer off
The combination meter assembly has a built-in buzzer.

Result
Result Proceed to
Data List Display Data List Display when Performing Active Test ON/OFF Operation
ON Changes between ON and OFF A
Does not change between ON and OFF B
OFF Changes between ON and OFF A
Does not change between ON and OFF B



A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Inspect the combination meter assembly (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

REPLACE COMBINATION METER ASSEMBLY

B

C