Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Brake Warning Light does not Come ON  


CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.INSPECT BRAKE WARNING LIGHT
a.

Disconnect the A24 skid control ECU (master cylinder solenoid) connector.


b.

Turn the ignition switch to ON.


c.

Check that the brake warning light comes on.

OK:

Brake warning light comes on.


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

2.CHECK CAN COMMUNICATION LINE

B

C

3.CHECK DTC (CAN COMMUNICATION SYSTEM)

A

4.PERFORM ACTIVE TEST USING GTS (INDICAT. LAMP BRAKE)

B

C

D

E

4.PERFORM ACTIVE TEST USING GTS (INDICAT. LAMP BRAKE)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the condition of the brake warning light by operating the GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Brake Brake Warning Light ON or OFF Perform the test with the vehicle stopped and engine idling.

OK:

The warning light turns on when operating the GTS.




OK

NG

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)