Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1434  Steering Angle Sensor Output Malfunction  


DESCRIPTION

Steering sensor signals are sent to the skid control ECU (master cylinder solenoid) via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering sensor zero point malfunction diagnostic function.

DTC Code DTC Detection Condition Trouble Area
C1434 An error in communication between the skid control ECU and the steering sensor, or an abnormal steering sensor zero point.
·

ECU-B1 fuse

·

ECU-IG No. 2 fuse

·

Steering sensor power supply

·

Steering sensor

·

Steering control ECU (w/ VGRS)



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the steering sensor, confirm that the replacement part is of the correct specification.

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



HINT:

When any of the speed sensors or the yaw rate sensor assembly has trouble, DTCs for the steering sensor may be stored even when the steering sensor is normal. When DTCs for the speed sensors or yaw rate sensor assembly are output together with DTCs for the steering sensor, inspect and repair the speed sensor and yaw rate sensor assembly first, and then inspect and repair the steering sensor.


PROCEDURE

1.CHECK DTC

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON again and check that no CAN communication system DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).


d.

Start the engine.


e.

Drive the vehicle at a speed of 35 km/h (22 mph) and turn the steering wheel to the right and left, and then check that no speed sensor or yaw rate sensor assembly DTCs are output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
No CAN communication system, speed sensor, or yaw rate sensor assembly DTCs are output A
CAN communication system DTC is output (for LHD) B
CAN communication system DTC is output (for RHD) C
Speed sensor or yaw rate sensor assembly DTC is output D

HINT:
·

If there is a malfunction in any of the speed sensors or the yaw rate sensor assembly, an abnormal value may be output although the steering sensor is normal.

·

If speed sensor and yaw rate sensor assembly DTCs are output simultaneously, repair these two sensors first, and then inspect the steering sensor.





A

2.CHECK HARNESS AND CONNECTOR (IG/ESS TERMINAL)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

C

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

D

2.CHECK HARNESS AND CONNECTOR (IG/ESS TERMINAL)

OK

3.CHECK HARNESS AND CONNECTOR (BAT TERMINAL)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (BAT TERMINAL)

A

B

4.CHECK HARNESS AND CONNECTOR (+BI TERMINAL)

C

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (+BI TERMINAL)

OK

5.CHECK HARNESS AND CONNECTOR (STEERING SENSOR - STEERING CONTROL ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (STEERING SENSOR - STEERING CONTROL ECU)

A

REPAIR OR REPLACE HARNESS OR CONNECTOR

B

C