Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255409 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.

Disable the Autoaway/Return function by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).

NOTICE:

Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.



b.

Turn the ignition switch on. Operate the tilt and telescopic switch to fully extend and lower the steering column.


c.

Turn the ignition switch off and disconnect the cable from the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45187 5.REMOVE LOWER NO. 3 STEERING WHEEL COVER

Hide 45100 7.REMOVE STEERING WHEEL ASSEMBLY

Hide 89245B 11.REMOVE STEERING ANGLE SENSOR

a.
C358533

Detach the 6 claws and remove the steering angle sensor.