Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › from 2015.08
RM2660E _54 Brake _052820 BRAKE SYSTEM (OTHER) _0255424 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432D 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 82666A 8.REMOVE NO. 2 CONNECTOR HOLDER

a.
C347210

Loosen the bolt and disconnect the connector from the No. 2 connector holder.

Text in Illustration
V113147

Remove in this Direction


b.
C347211E01
2.042,0.448 2.177,0.625 0.135,0.177 10 true A 1.135,0.448 1.271,0.625 0.135,0.177 10 true A 1.823,1.677 1.958,1.854 0.135,0.177 10 true B

Disconnect the wire harness clamp from the brake pedal support assembly.


c.

Detach the two claws (A) of the No. 2 connector holder.

Text in Illustration
V113147

Pull Towards You


d.

Unlock the claw (B), and then pull the No. 2 connector holder towards you to remove it.


Hide 47264A 9.REMOVE PUSH ROD PIN

a.
C177105E02
0.123,0.024 0.350,0.228 0.228,0.205 10 *A 0.123,2.235 0.350,2.440 0.228,0.204 10 *B

Remove the clip and push rod pin from the brake pedal lever.

Text in Illustration
*A for Automatic Transmission
*B for Manual Transmission


Hide 84340 10.REMOVE STOP LIGHT SWITCH ASSEMBLY

a.

Disconnect the stop light switch connector.


b.

Remove the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).


Hide 11.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
U165103E01
0.142,0.137 0.367,0.314 0.225,0.177 10 *A 0.142,2.38 0.367,2.557 0.225,0.177 10 *B

Loosen the hexagon bolt.

Text in Illustration
*A for Automatic Transmission
*B for Manual Transmission

HINT:

Hold the bolt in place and loosen the nut.


NOTICE:

Only loosen the nut. Do not remove the bolt or nut.



b.

Remove the brake pedal support reinforcement set bolt.


c.
C177106E02
0.133,0.088 0.363,0.286 0.230,0.198 10 *A 0.133,2.305 0.363,2.503 0.230,0.198 10 *B 1.408,1.637 1.223,1.865 false

Remove the 4 nuts and brake pedal support assembly.

Text in Illustration
*A for Automatic Transmission
*B for Manual Transmission