1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT WHEEL RH
53782
4.REMOVE FRONT FENDER APRON TRIM PACKING A
11259
5.REMOVE V-BANK COVER SUB-ASSEMBLY
17880
6.REMOVE AIR CLEANER HOSE ASSEMBLY
17700
7.REMOVE AIR CLEANER ASSEMBLY
16361A
8.REMOVE FAN AND GENERATOR V BELT
9.DRAIN POWER STEERING FLUID
10.DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
Detach the wire harness clamp and disconnect the connector.
44410
11.DISCONNECT PRESSURE FEED TUBE
Remove the bolt and disconnect the pressure feed tube.
| *1 | Pressure feed tube |
Remove the gasket.
88712
12.DISCONNECT SUCTION HOSE
Slide the clip and disconnect the suction hose from the vane pump.
44320
13.REMOVE VANE PUMP ASSEMBLY
Remove the 2 bolts and vane pump.