Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 3UR-FE) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255440 VANE PUMP(for 3UR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 3UR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT WHEEL RH

Hide 53782 4.REMOVE FRONT FENDER APRON TRIM PACKING A

Hide 9.DRAIN POWER STEERING FLUID

Hide 10.DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR (w/o Variable Flow Control Solenoid Valve)

a.
C172783

Detach the wire harness clamp and disconnect the connector.


Hide 44410 11.DISCONNECT PRESSURE FEED TUBE (w/o Variable Flow Control Solenoid Valve)

a.
U164698E02
2.427,1.323 2.302,1.323 false 2.313,1.323 2.083,1.771 false 1.031,0.146 1.24,0.365 0.208,0.219 10 true *1

Remove the union bolt and disconnect the pressure feed tube.

Text in Illustration
*1 Pressure feed tube


b.

Remove the gasket.


Hide 44410 12.DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.
C335472

Detach the 2 wire harness clamps and disconnect the 2 connectors.


b.
C335473

Remove the union bolt and disconnect the pressure feed tube.


c.

Remove the gasket.


Hide 88712 13.DISCONNECT SUCTION HOSE (w/o Variable Flow Control Solenoid Valve)

a.
C172782

Slide the clip and disconnect the suction hose from the vane pump.


Hide 44348A 14.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE (w/ Variable Flow Control Solenoid Valve)

a.
C335474

Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the oil reservoir.


b.

Remove the bolt and No. 1 oil reservoir to pump hose from the vane pump.


Hide 44320 15.REMOVE VANE PUMP ASSEMBLY

a.
C161012

Remove the 2 bolts and vane pump.