Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1UR-FE) › 2014.08–2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255442 VANE PUMP(for 1UR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1UR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT WHEEL RH

Hide 53782 4.REMOVE FRONT FENDER APRON TRIM PACKING A

Hide 8.DRAIN POWER STEERING FLUID

Hide 9.DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

a.
C172783

Detach the wire harness clamp and disconnect the connector.


Hide 44410 10.DISCONNECT PRESSURE FEED TUBE

a.
U164697E02
2.427,1.323 2.302,1.323 false 2.313,1.323 2.083,1.771 false 1.031,0.146 1.281,0.365 0.25,0.219 10 true *1

Remove the bolt and disconnect the pressure feed tube.

Text in Illustration
*1 Pressure Feed Tube


b.

Remove the gasket.


Hide 88712 11.DISCONNECT SUCTION HOSE

a.
C172782

Slide the clip and disconnect the suction hose from the vane pump.


Hide 44320 12.REMOVE VANE PUMP ASSEMBLY

a.
C161012

Remove the 2 bolts and vane pump.