Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM J

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  Steering Wheel is Off-center or Deviates from Neutral Position  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the steering actuator assembly, perform actuator angle neutral point calibration and initialization after replacement (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CHECK IF STEERING WHEEL IS CENTERED

B

2.CHECK IF STEERING WHEEL IS CENTERED
a.

Check if the neutral position of the steering wheel is always incorrect.

Result
Result Proceed to
The steering wheel neutral position is always incorrect A
The steering wheel neutral position deviated in the past, but is now correct. B



A

3.CHECK TIRE SIZE

B

6.CUSTOMER PROBLEM ANALYSIS
3.CHECK TIRE SIZE
a.

Check all the tires.

Result
Result Proceed to
All tire sizes are correct and tire pressures are normal A
Size of any tire is incorrect B
All tire sizes are correct, but tire pressures are incorrect C



A

4.CUSTOMER PROBLEM ANALYSIS

B

REPLACE WITH SPECIFIED SIZE TIRE

C

ADJUST TIRE PRESSURE TO SPECIFIED VALUE

4.CUSTOMER PROBLEM ANALYSIS
a.

Check if a front wheel alignment adjustment has been performed in the past. Also, if an adjustment has been performed, check if actuator angle neutral point calibration and initialization was performed.

Result
Result Proceed to
·

A front wheel alignment adjustment has not been performed.

·

After a front wheel alignment adjustment was performed, actuator angle neutral point calibration and initialization was performed.


A
After a front wheel alignment adjustment was performed, actuator angle neutral point calibration and initialization was not performed. B



A

5.CHECK STEERING SENSOR ZERO POINT

B

PERFORM STEERING ANGLE ADJUSTMENT AND VGRS SYSTEM CALIBRATION

5.CHECK STEERING SENSOR ZERO POINT
a.

Position the tires straight ahead.


b.

Turn the engine switch off.


c.

Disconnect the steering actuator assembly connector from the VGRS ECU (steering control ECU).


d.

Perform a driving test and check whether the steering neutral position changes after the test.

OK:

The position does not change.




OK

PERFORM STEERING ANGLE ADJUSTMENT AND VGRS SYSTEM CALIBRATION

NG

PERFORM FRONT AND REAR WHEEL ALIGNMENT ADJUSTMENT

6.CUSTOMER PROBLEM ANALYSIS
a.

Confirm the conditions present when the steering wheel neutral position deviates.

Result
Result Proceed to
·

The neutral position deviated when the steering wheel was turned abruptly. However, when the steering wheel is slowly turned, no deviation occurs.

·

The neutral position deviated when the required effort to turn the steering wheel increased, such as when repeatedly turning the steering wheel when the vehicle is stopped or when turning the steering wheel when the tires are up against a curb.

·

The neutral position deviated when the required effort to turn the steering wheel increased under conditions different than the 2 conditions listed above.

·

The neutral position deviated when the battery was fully depleted.


A
The steering wheel neutral position deviated when the required steering effort was normal. B

HINT:
·

When the steering wheel is turned abruptly, the required steering effort may increase and the neutral position may deviate.

·

When the steering torque is large, the actuator easily overheats. In this situation, the system is stopped to prevent the actuator from overheating.





A

END

B

REPLACE STEERING ACTUATOR ASSEMBLY