Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM J

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  Steering Wheel Vibrates or Abnormal Noise is Heard from Steering Wheel  


CAUTION / NOTICE / HINT

HINT:

Check that no DTC is output for the VGRS system and vehicle stability control system.


PROCEDURE

1.CHECK STEERING WHEEL CONDITION
a.

Center the steering wheel.


b.

Turn the engine switch off.


c.

Disconnect the steering actuator connector.


d.

Start the engine.


e.

Check for abnormal noise or vibration while turning the steering wheel.

OK:

No abnormal noise or vibration.


NOTICE:

DTC C15A5/65 is stored when the engine is running with the connector disconnected from the steering actuator. Clear the DTC after this check.




OK

REPLACE STEERING ACTUATOR ASSEMBLY

NG

REPAIR OR REPLACE STEERING COLUMN ASSEMBLY (TILT STEERING GEAR ASSEMBLY WITH MOTOR)