Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM J

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  Master Warning Light Malfunction  


DESCRIPTION

If the steering control ECU detects that the VGRS system has a malfunction, warning information is transmitted to the combination meter via CAN communication.

The combination meter will turn the master warning light on based on this information.

Warning information is transmitted via the following route:

·

Steering control ECU → (CAN) → Network gateway ECU → (CAN) → Combination meter


Connecting terminals TC and CG of the DLC3 makes the master warning light blink and outputs DTCs.

WIRING DIAGRAM

C177546E01
4.256,2.204 5.489,2.406 1.232,0.203 10 Combination Meter 4.256,2.067 4.558,2.229 0.302,0.163 10 E7 1.769,2.208 3.293,2.387 1.524,0.180 10 Steering Control ECU 1.769,2.057 2.070,2.220 0.302,0.163 10 E79

CAUTION / NOTICE / HINT

HINT:

Check that there is no problem in CAN communication before performing the following procedure.

If there are any problems in CAN communication, first troubleshoot them and then proceed to the troubleshooting below.


PROCEDURE

1.CHECK BATTERY
a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Positive (+) battery terminal - negative (-) battery terminal Always 11 to 14 V




OK

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (COMBINATION METER)

NG

RECHARGE OR REPLACE BATTERY

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (COMBINATION METER)
a.

Select the Active Test, use the intelligent tester to generate a control command, and then check that the master warning light turns on/off.

Combination Meter:
Tester Display Test Part Control Range Diagnostic Note
Master Warning Master warning light OFF/ON Confirm that the vehicle is stopped and the engine is running

OK:

Indicator light turns on/off.


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B

C