Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C15A1/61  Actuator Malfunction  


DESCRIPTION

The steering control ECU drives the actuator while the steering wheel is turned to set the gear ratio. It detects the current flowing into the actuator motor driving circuit.

If the steering control ECU detects excessive current, it will store DTC C15A1/61, turn on the master warning light, and stop VGRS operation.

DTC Code DTC Detection Condition Trouble Area
C15A1/61 Excessive current (exceeding the estimated amount) flows due to a malfunction in the motor drive circuit.
·

Harness or connector

·

Steering actuator

·

Steering control ECU



WIRING DIAGRAM

C163899E04
0.383,2.725 1.581,3.072 1.198,0.346 10 Steering Actuator 5.354,2.884 6.779,3.067 1.424,0.184 10 Steering Control ECU 5.354,2.722 5.677,2.906 0.323,0.184 10 E78 5.691,0.774 6.101,1.003 0.410,0.228 10 BMU 5.691,1.23 6.097,1.460 0.406,0.230 10 BMV 5.691,1.699 6.106,1.905 0.415,0.207 10 BMW 5.691,2.163 6.171,2.398 0.480,0.235 10 SG 0.866,0.774 1.331,1.003 0.465,0.228 10 BMU+ 0.87,1.23 1.330,1.460 0.460,0.230 10 BMV+ 0.834,1.699 1.305,1.905 0.471,0.207 10 BMW+ 3.345,2.362 3.983,2.588 0.637,0.225 10 Shielded 1.399,0.667 1.581,0.850 0.182,0.182 10 4 1.399,1.134 1.581,1.316 0.182,0.182 10 5 1.387,1.596 1.597,1.778 0.210,0.182 10 13 5.469,0.684 5.625,0.868 0.156,0.184 10 2 5.469,1.142 5.625,1.326 0.156,0.184 10 1 5.469,1.616 5.625,1.800 0.156,0.184 10 3 5.469,2.074 5.625,2.258 0.156,0.184 10 6 0.383,2.558 0.706,2.741 0.323,0.184 10 E80

CAUTION / NOTICE / HINT

HINT:

When DTC C15A2/62 is output, a short circuit inside the steering actuator or inside the steering control ECU is suspected.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEERING CONTROL ECU - STEERING ACTUATOR)
U164824E02
2.625,1.854 3,1.729 false 2.625,1.958 3.021,2.198 false 2.26,1.854 1.958,2.156 false 4.802,2.073 4.479,2.438 false 5.021,1.969 5.313,2.458 false 4.417,1.677 4.823,1.958 false 4.198,0.156 6.688,0.552 2.49,0.396 10 false Rear view of wire harness connector: (to Steering Actuator) 0.75,0.135 3.24,0.531 2.49,0.396 10 false Rear view of wire harness connector: (to Steering Control ECU) 4.063,0.969 4.354,1.135 0.292,0.167 10 false E80 2.292,0.854 2.583,1.021 0.292,0.167 10 false E78 1.75,2.177 2.323,2.333 0.573,0.156 10 false 2 (BMU) 3.031,1.656 3.573,1.854 0.542,0.198 10 false 1 (BMV) 3.042,2.125 3.615,2.302 0.573,0.177 10 false 3 (BMW) 3.781,1.594 4.458,1.792 0.677,0.198 10 false 5 (BMV+) 4.01,2.479 4.76,2.667 0.75,0.188 10 false 13 (BMW+) 5.083,2.479 5.74,2.667 0.656,0.188 10 false 4 (BMU+)

a.

Disconnect the E78 steering control ECU connector.


b.

Disconnect the E80 steering actuator connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E78-1 (BMV) - E78-2 (BMU) Always 10 kΩ or higher
E78-1 (BMV) - E78-3 (BMW)
E78-2 (BMU) - E78-3 (BMW)
E78-1 (BMV) - E80-5 (BMV+) Always Below 1 Ω
E78-2 (BMU) - E80-4 (BMU+)
E78-3 (BMW) - E80-13 (BMW+)
E78-1 (BMV) - Body ground Always 10 kΩ or higher
E78-2 (BMU) - Body ground
E78-3 (BMW) - Body ground




OK

2.CHECK STEERING ACTUATOR

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK STEERING ACTUATOR
a.
U164530E02
2.563,2.656 2.031,3.042 true 2.135,2.625 1.74,2.802 true 2.615,2.781 2.927,2.958 true 0.167,0.146 2.375,0.552 2.208,0.406 10 false Rear view of wire harness connector: (to Steering Control ECU) 1.438,2.979 2.021,3.177 0.583,0.198 10 false 1 (BMV) 1.156,2.74 1.76,2.906 0.604,0.167 10 false 2 (BMU) 2.677,2.99 3.281,3.156 0.604,0.167 10 false 3 (BMW) 2.229,1.406 2.563,1.604 0.333,0.198 10 false E78

Disconnect the E78 steering control ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

HINT:

The resistance must be measured with the steering actuator connector connected.


Standard Resistance:
Tester Connection Condition Specified Condition
E78-1 (BMV) - E78-2 (BMU) Always Below 1 Ω
E78-1 (BMV) - E78-3 (BMW)
E78-2 (BMU) - E78-3 (BMW)
E78-1 (BMV) - Body ground Always 10 kΩ or higher
E78-2 (BMU) - Body ground
E78-3 (BMW) - Body ground


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

REPLACE STEERING ACTUATOR ASSEMBLY

B

C