The steering control ECU monitors PIG (motor power source voltage) and detects a malfunction in the power supply relay (located inside the steering control ECU).
If the steering control ECU detects a malfunction, it will turn on the master warning light, store these DTCs, and stop VGRS operation.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C15C7/78 | The steering control ECU detects that the IG terminal voltage is between 9 and 16 V, and the PIG terminal voltage is below 7 V or higher than 18.5 V for 2.4 seconds. | ·
Harness or connector ·
Steering control ECU |
| C15C8/79 | The steering control ECU detects a malfunction in the power source relay or an open circuit. | ·
Harness or connector ·
Steering control ECU |
The fault may be intermittent. Check the harnesses and connectors thoroughly and retest.
Record and clear the DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E77-7 (PGND) - Body ground | Always | Below 1 Ω |
| E78-8 (PGD2) - Body ground |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E77-8 (PIG) - Body ground | Always | 11 to 14 V |
OK
NG
Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| C15C7/78 or C15C8/79 is not output | A |
| C15C7/78 or C15C8/79 is output (for LHD) | B |
| C15C7/78 or C15C8/79 is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C