Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C15B1/71  ECU Malfunction(CPU)  C15B3/73  ECU Malfunction(Substrate Temperature Sensor)  C15B5/82  ECU Malfunction(Flash Memory)  C15B6/83  ECU Malfunction(EEPROM)  


DESCRIPTION

If the VGRS ECU (steering control ECU) detects an internal malfunction, it turns the master warning light on, and stores these DTCs.

When DTC C15B3/73 is stored, the master warning light is not illuminated and the VGRS system continues to operate.

DTC No. DTC Detection Condition Trouble Area
C15B1/71 When the engine switch is turned on (IG), the VGRS ECU (steering control ECU) detects an internal malfunction. VGRS ECU (steering control ECU)
C15B3/73 When the engine switch is turned on (IG), the VGRS ECU (steering control ECU) detects an internal malfunction. VGRS ECU (steering control ECU)
C15B5/82 When the engine switch is turned on (IG), the VGRS ECU (steering control ECU) detects an internal malfunction. VGRS ECU (steering control ECU)
C15B6/83 When the engine switch is turned on (IG), the VGRS ECU (steering control ECU) detects an internal malfunction. VGRS ECU (steering control ECU)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the VGRS ECU (steering control ECU), perform actuator angle neutral point calibration and initialization after replacement (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.REPLACE VGRS ECU (STEERING CONTROL ECU)

NEXT

END