Home › Steering › VARIABLE GEAR RATIO STEERING › STEERING CONTROL ECU (for RHD) › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255451 STEERING CONTROL ECU(for RHD) A

VARIABLE GEAR RATIO STEERING  STEERING CONTROL ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 3.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 89181A 5.REMOVE STEERING CONTROL ECU

a.

Remove the bolt and 2 nuts.

C335466


b.

Disconnect the connectors from the junction block.


c.
C335467

Remove the bolt, detach the claw and remove steering control ECU from the junction block.