Home › Steering › VARIABLE GEAR RATIO STEERING › STEERING CONTROL ECU (for LHD) › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255450 STEERING CONTROL ECU(for LHD) A

VARIABLE GEAR RATIO STEERING  STEERING CONTROL ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 73900 2.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55312 3.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 5.REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK

a.
C333711

Disconnect the connectors and wire harness clamp.


Hide 89181A 6.REMOVE STEERING CONTROL ECU

a.
C333712

Remove the 2 bolts, 2 claws and steering control ECU from the junction block.