Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55449C
2.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
3.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55474C
4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55432D
7.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55446A
8.REMOVE NO. 1 SWITCH HOLE BASE
84255
9.REMOVE STEERING HEATER SWITCH
Detach the 2 claws to remove the steering heater switch from the lower instrument panel finish panel sub-assembly.