Use the same procedures for the RHD and LHD.
The procedures listed below are the LHD side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55510F
2.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
55670
3.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
4.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
86120
5.REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
55412C
6.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)
84330
7.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Detach the 2 claws and remove the hazard warning switch.