Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255474 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  INSTALLATION  


PROCEDURE

Hide 86101 1.INSTALL ANTENNA CORD SUB-ASSEMBLY (w/o Multi-display)

a.

for LHD:

Attach the 7 clamps to install the antenna cord.

B181730


b.

for RHD:

Attach the 5 clamps to install the antenna cord.

B181732


Hide 86101 2.INSTALL ANTENNA CORD SUB-ASSEMBLY (w/ Multi-display)

a.

for LHD:

Attach the 8 clamps to install the antenna cord.

B181729


b.

for RHD:

Attach the 6 clamps to install the antenna cord.

B181731


Hide 55400 3.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY

a.

Install the instrument panel safety pad (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 86101S 4.INSTALL ANTENNA CORD SUB-ASSEMBLY

a.

w/o Sliding Roof:

i.

Apply new double-sided tape as shown in the illustration.

HINT:

Attach double-sided tape to the hatched areas shown in the illustration below.


U164110E01
0.475,9.056 1.999,9.261 1.524,0.205 10 Double-sided Tape 0.475,9.398 1.165,9.560 0.691,0.163 10 Red Tape 1.621,1.371 2.092,1.545 0.471,0.174 10 B Area 3.842,3.836 4.313,4.011 0.471,0.174 10 B Area 0.432,3.836 0.903,4.010 0.471,0.174 10 A Area 0.217,6.359 0.688,6.534 0.471,0.174 10 A Area


ii.

Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.


iii.

Attach the 2 clamps and fit the antenna into the notch.



b.

w/ Sliding Roof:

i.

Apply new double-sided tape as shown in the illustration.

HINT:

Attach double-sided tape to the hatched areas shown in the illustration below.

U155830E01
2.008,3.447 2.453,3.630 0.445,0.184 10 A Area 5.371,3.446 5.863,3.593 0.492,0.147 10 B Area 0.485,9.07 1.986,9.223 1.501,0.154 10 Double-sided Tape 0.487,9.418 1.233,9.560 0.746,0.142 10 Red Tape 0.274,6.457 0.719,6.641 0.445,0.184 10 A Area 2.091,1.002 2.584,1.149 0.492,0.147 10 B Area



ii.

Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.


iii.

Attach the 4 clamps and fit the antenna into the notch.



Hide 63310 5.INSTALL ROOF HEADLINING ASSEMBLY

a.

w/o Sliding Roof:

Install the roof headlining (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>INSTALLATION).


b.

w/ Sliding Roof:

Install the roof headlining (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION).


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.CHECK SRS WARNING LIGHT