Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/ Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255478 AUDIO AND VISUAL SYSTEM(w/ Navigation System) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Navigation System)  B15C2  Speed Signal Malfunction  


DESCRIPTION

The multi-media module receiver assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna, and then adjusts the vehicle position on the map. The multi-media module receiver assembly stores this DTC when the difference between the speed information that the navigation antenna assembly receives and the SPD pulse received from the combination meter assembly becomes large.

HINT:
·

A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.

·

If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.



DTC Code DTC Detection Condition Trouble Area
B15C2 A difference between the GPS speed and SPD pulse is detected
·

Combination meter assembly

·

Multi-media module receiver assembly

·

Harness or connector



WIRING DIAGRAM

E240105E76
5.021,1.813 5.313,1.979 0.292,0.167 10 false F77 5.021,2.01 6.333,2.427 1.313,0.417 10 false Multi-media Module Receiver Assembly 4.969,0.948 5.156,1.125 0.188,0.177 10 false 56 5.188,1.073 5.531,1.24 0.344,0.167 10 false SPD 1.813,1.063 2.01,1.24 0.198,0.177 10 false +S 2.063,0.958 2.271,1.135 0.208,0.177 10 false 4 0.771,1.76 1.063,1.927 0.292,0.167 10 false E7 0.771,1.906 2.635,2.083 1.865,0.177 10 false Combination Meter Assembly

PROCEDURE

2.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

NG

3.CHECK VEHICLE SENSOR (OPERATION CHECK)
3.CHECK VEHICLE SENSOR (OPERATION CHECK)
a.
E176549

Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensor in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>OPERATION CHECK).


b.

While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

HINT:

The combination meter assembly receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.


OK:

Vehicle speed displayed on the "Vehicle Sensors" screen is almost the same as the actual vehicle speed measured using the intelligent tester (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DATA LIST / ACTIVE TEST).




OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG