The sound signals amplified by the radio receiver assembly are sent to the speakers from the radio receiver assembly via the speaker circuit.
If there is a short in a speaker circuit, the radio receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is not a malfunction in the radio receiver assembly or speakers.
*1: for RH Side
*2: for LH Side
Disconnect the F113 and F112 radio receiver assembly connectors.
Disconnect the I1*1 and/or I10*2 front No. 1 speaker assembly connector.
Disconnect the F7*1 and/or F8*2 front No. 2 speaker assembly connector.
Disconnect the J15*1 and/or J17*2 rear speaker set connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F112-1 (FR+) - F7-1 (+) | Always | Below 1 Ω |
| F112-5 (FR-) - F7-3 (-) | Always | Below 1 Ω |
| F7-2 (TWR+) - I1-1 | Always | Below 1 Ω |
| F7-4 (TWR-) - I1-2 | Always | Below 1 Ω |
| F113-1 (RR+) - J15-1 | Always | Below 1 Ω |
| F113-3 (RR-) - J15-2 | Always | Below 1 Ω |
| F112-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| F112-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| F7-2 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F7-4 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F113-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| F113-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F112-2 (FL+) - F8-1 (+) | Always | Below 1 Ω |
| F112-6 (FL-) - F8-3 (-) | Always | Below 1 Ω |
| F8-2 (TWL+) - I10-1 | Always | Below 1 Ω |
| F8-4 (TWL-) - I10-2 | Always | Below 1 Ω |
| F113-2 (RL+) - J17-1 | Always | Below 1 Ω |
| F113-6 (RL-) - J17-2 | Always | Below 1 Ω |
| F112-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| F112-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| F8-2 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F8-4 (TWL-) - Body ground | Always | 10 kΩ or higher |
| F113-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| F113-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 1 speaker assembly LH and/or RH (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL).
Inspect the front No. 1 speaker assembly LH and/or RH (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION).
OK
NG
Replace the front No. 2 speaker LH and/or RH with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL).
Check that the malfunction disappears.
Connect all the connectors that were disconnected from the front No. 2 speaker assemblies.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
Malfunction disappears.
OK
NG
Remove the rear speaker set LH and/or RH (Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Inspect the rear speaker set LH and/or RH (Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION).
OK
NG