Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  AVC-LAN Circuit  


DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.

If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

WIRING DIAGRAM

E248832E03
1.068,1.132 1.391,1.309 0.323,0.177 10 TX- 1.068,0.628 1.391,0.804 0.323,0.177 10 TX+ 1.439,0.516 1.658,0.692 0.218,0.177 10 11 1.439,0.985 1.658,1.162 0.218,0.177 10 10 0.368,1.468 0.655,1.631 0.288,0.163 10 F75 0.361,1.608 1.669,1.778 1.309,0.170 10 Parking Assist ECU* 3.044,0.635 3.442,0.804 0.399,0.170 10 TX1+ 3.044,1.097 3.442,1.267 0.399,0.170 10 TX1- 3.555,0.635 3.954,0.804 0.399,0.170 10 TX3+ 3.555,1.097 3.954,1.267 0.399,0.170 10 TX3- 5.579,0.635 5.978,0.804 0.399,0.170 10 TX+ 5.579,1.097 5.978,1.267 0.399,0.170 10 TX- 2.889,0.523 3.045,0.685 0.156,0.163 10 7 5.404,0.523 5.560,0.685 0.156,0.163 10 7 2.889,1.006 3.045,1.169 0.156,0.163 10 8 3.996,0.523 4.194,0.699 0.198,0.177 10 45 3.996,1.013 4.194,1.190 0.198,0.177 10 46 5.362,1.013 5.560,1.190 0.198,0.177 10 19 2.854,1.531 3.184,1.701 0.330,0.170 10 F77 2.847,1.685 4.191,2.057 1.343,0.371 10 Multi-media Module Receiver Assembly 5.376,1.706 5.706,1.876 0.330,0.170 10 F79 5.369,1.861 6.965,2.051 1.596,0.191 10 Multi-display Assembly 0.767,2.295 2.826,2.472 2.059,0.177 10 : AVC-LAN Communication Line 0.178,2.036 1.855,2.219 1.677,0.184 10 *: w/ Side Monitor System

PROCEDURE

1.INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY
a.
E238990E58
2.385,1.021 2.854,0.583 false 2.229,1.031 1.906,0.667 false 2.271,1.365 2,1.771 false 2.365,1.354 2.635,1.719 false 2.906,0.448 3.302,0.625 0.396,0.177 10 false TX1+ 1.802,1.802 2.198,1.979 0.396,0.177 10 false TX3- 2.5,1.75 2.896,1.927 0.396,0.177 10 false TX3+ 1.625,0.563 2.021,0.74 0.396,0.177 10 false TX1-

Remove the multi-media module receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/ Multi-display)>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (TX1+) - 8 (TX1-) Always 60 to 80 Ω
45 (TX3+) - 46 (TX3-) Always 60 to 80 Ω




OK

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)
HINT:

For details of the connectors, refer to Terminals of ECU (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>TERMINALS OF ECU).


a.

Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.

i.

Disconnect all connectors in all AVC-LAN circuits.


ii.

Check for an open or short in all AVC-LAN circuits.

OK:

There is no open or short circuit.





OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

HINT:
·

Check all slave units.

·

When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.



OK:

Master unit returns to normal operation.




OK

REPLACE MALFUNCTIONING PARTS

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE