Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › FRONT AND SIDE MONITOR MAIN SWITCH › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255509 FRONT AND SIDE MONITOR MAIN SWITCH A

PARK ASSIST / MONITORING  FRONT AND SIDE MONITOR MAIN SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. DISABLE AUTO TILT AWAY FUNCTION

a.

Disable the function by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).

NOTICE:

Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.



b.

Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.


c.

Turn the engine switch off.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55474C 4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55449C 5.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 6.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55475A 7.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55404C 8.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.
E155398

Detach the 4 claws.


b.
E154732

Detach the 9 claws.


c.

w/ Multi-information Display:

Remove the finish panel and disconnect the 2 connectors.


d.

w/o Multi-information Display:

Remove the finish panel and disconnect the connector.


Hide 84480F 9.REMOVE MAIN SWITCH ASSEMBLY

a.
E247872E01
0.043,0 0.271,0.228 0.228,0.228 10 *A 0.043,2.303 0.271,2.532 0.228,0.228 10 *B

Detach the 2 claws and remove the main switch assembly.

Text in Illustration
*A for LHD
*B for RHD