Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255512 PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) U

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)  TERMINALS OF ECU  


PARKING ASSIST ECU


U166301E02
4.802,0.302 5.156,0.563 0.354,0.26 10 false F75 3.229,0.302 3.552,0.521 0.323,0.219 10 false F76 2,0.313 2.323,0.542 0.323,0.229 10 false F88

a.

Disconnect the F75 and F76 parking assist ECU connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F75-1 (+B) - F75-4 (GND1) L - W-B Power source signal Always 11 to 14 V
F75-4 (GND1) - Body ground W-B - Body ground Ground Always Below 1 Ω
F75-8 (IG) - F75-4 (GND1) G - W-B IG power source signal Engine switch on (IG) 11 to 14 V
Engine switch off Below 1 V
F75-9 (ACC) - F75-4 (GND1) GR - W-B ACC power source signal Engine switch on (ACC) 11 to 14 V
Engine switch off Below 1 V
F76-7 (BLSW) - F75-4 (GND1) G - W-B Front and side monitor main switch power source signal Engine switch on (IG), front and side monitor main switch on 11 to 14 V


c.

Reconnect the F75 and F76 parking assist ECU connectors.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F75-10 (TX-) L AVC-LAN communication signal - -
F75-11 (TX+) W AVC-LAN communication signal - -
F76-38 (CV-) - F75-37 (CGND) W - Shielded Rear television camera ground Always Below 1 V
F76-15 (CV+) - F75-37 (CGND) R - Shielded Rear television camera display signal (NTSC) input Engine switch on (IG), shift lever in R Pulse generation (See waveform)
F76-37 (CGND) - F75-4 (GND1) Shielded - W-B Rear television camera ground (shield) Always Below 1 V
F76-14 (CB+) - F75-37 (CGND) B - Shielded Power source to rear television camera Engine switch on (IG), shift lever in R 5.5 to 7.05 V


e.

Using an oscilloscope, check waveform.

E349782E01
1.031,2.406 1.146,2.406 1.146,2.406 1.25,1.896 false 1.583,2.427 1.458,2.427 1.458,2.427 1.365,1.792 false 4.594,2.427 4.688,2.427 4.688,2.427 4.781,1.781 false 5.135,2.417 5.01,2.417 5.01,2.417 4.906,1.708 false 0.563,0.448 0.875,0.646 0.313,0.198 10 false *a 4.135,0.458 4.448,0.656 0.313,0.198 10 false *b 0.49,1.344 0.948,1.542 0.458,0.198 10 false GND 3.969,1.365 4.427,1.563 0.458,0.198 10 false GND 0.854,2.313 1.167,2.51 0.313,0.198 10 false *c 1.615,2.354 1.927,2.552 0.313,0.198 10 false *d 4.365,2.333 4.677,2.531 0.313,0.198 10 false *c 5.229,2.323 5.542,2.521 0.313,0.198 10 false *d

Text in Illustration
*a Waveform A (camera lens not covered, displaying an image)
*b Waveform B (camera lens covered, blacking out the screen)
*c Synchronized Signal
*d Video Waveform

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.


i.

Waveform

Item Content
Terminal No. (Symbol) F76-15 (CV+) - F75-37 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition
·

Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image.

·

Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen.






REAR TELEVISION CAMERA ASSEMBLY


U165782E02
3.5,0.115 3.833,0.344 0.333,0.229 10 false S5

a.

Disconnect the S5 rear television camera assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
S5-3 (CGND) - Body ground BR - Body ground Ground Always Below 1 Ω
S5-4 (CB+) - S5-3 (CGND) B - BR Power source Engine switch on (IG), shift lever in R 5.5 to 7.05 V


c.

Reconnect the S5 rear television camera assembly connector.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the parking assist ECU with the connector connected. If the result is not as specified, the rear television camera assembly may have a malfunction.



d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
S5-2 (CV+) - S5-3 (CGND) R - BR Display signal Engine switch on (IG), shift lever in R Pulse generation (See waveform)
S5-1 (CV-) - S5-3 (CGND) W - BR Rear television camera ground Always Below 1 V


e.

Using an oscilloscope, check waveform.

E349782E01
1.031,2.406 1.146,2.406 1.146,2.406 1.25,1.896 false 1.583,2.427 1.458,2.427 1.458,2.427 1.365,1.792 false 4.594,2.427 4.688,2.427 4.688,2.427 4.781,1.781 false 5.135,2.417 5.01,2.417 5.01,2.417 4.906,1.708 false 0.563,0.448 0.875,0.646 0.313,0.198 10 false *a 4.135,0.458 4.448,0.656 0.313,0.198 10 false *b 0.49,1.344 0.948,1.542 0.458,0.198 10 false GND 3.969,1.365 4.427,1.563 0.458,0.198 10 false GND 0.854,2.313 1.167,2.51 0.313,0.198 10 false *c 1.615,2.354 1.927,2.552 0.313,0.198 10 false *d 4.365,2.333 4.677,2.531 0.313,0.198 10 false *c 5.229,2.323 5.542,2.521 0.313,0.198 10 false *d

Text in Illustration
*a Waveform A (camera lens not covered, displaying an image)
*b Waveform B (camera lens covered, blacking out the screen)
*c Synchronized Signal
*d Video Waveform

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.


i.

Waveform

Item Content
Terminal No. (Symbol) S5-2 (CV+) - S5-3 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition
·

Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image.

·

Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen.







MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) [w/o Power Back Door System] (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>TERMINALS OF ECU)



POWER BACK DOOR UNIT ASSEMBLY [w/ Power Back Door System] (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>TERMINALS OF ECU)