Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC No. DTC Detection Condition Trouble Area
C1AB8 The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.

·

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTC
a.

Check for CAN communication system DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
CAN communication system DTCs are not output. A
CAN communication system DTCs are output. (for LHD) B
CAN communication system DTCs are output. (for RHD) C



A

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B

C

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTCs are output. A
DTC C1AB8 is output ("Blind Spot Monitor Master"). B
DTC C1AB8 is output ("Blind Spot Monitor Slave"). C



A

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)

B

C