Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC No. DTC Detection Condition Trouble Area
U1331 Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.
·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.

·

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.



PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
a.

Check the main body ECU (multiplex network body ECU) part number.

i.

Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

Result
Result Proceed to
The part number is correct. A
The part number is incorrect (for LHD). B
The part number is incorrect (for RHD). C




A

2.CHECK FOR DTC

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

2.CHECK FOR DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTCs are output. A
DTC U1331 is output ("Blind Spot Monitor Master"). B
DTC U1331 is output ("Blind Spot Monitor Slave"). C



A

B

C