Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255517 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored if the multi-media module receiver assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.

DTC Code Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering sensor
·

Steering sensor

·

Multi-media module receiver assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the multi-display after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION).



PROCEDURE

1.REPLACE STEERING SENSOR
a.

Replace the steering sensor with a new or known good one (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Recheck for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1626 is not output A
DTC C1626 is output B



A

END (STEERING SENSOR IS DEFECTIVE)

B

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY